GT350 Regular Splitter "SHELBY" Inlays

• These vinyl inlays are designed to fit in the "SHELBY" lettering of the regular non-R front lip splitter of the 16-20 GT350

 

Difficulty: 2 of 5

• Die-cut high-quality vinyl letters (3M, Avery, Oracal, etc.)
• Last up to 8 years with proper installation and care

Install Video 

• Clean the surface well with at least 91% isopropyl alcohol making sure the area is stripped off of any dressings, waxes, sealants, or ceramic coatings
• Gloves are recommended to avoid body oils from our hands interfering with the vinyl's adhesive
• Can be installed dry or wet

Dry installation 

• Remove each vinyl letter one at a time from the backing paper
• Use a flat card squeegee or a corner tool squeegee to guide and install each letter
• Go over each letter to ensure proper placement of the vinyl

Wet installation 

• Remove each vinyl letter one at a time from the backing paper
• Use a soapy water solution (1 spray MAX per letter) to the adhesive side of the letter and place it into your desired position
• Go over each letter with a flat squeegee card or a corner tool squeegee to ensure any excess moisture is removed
• Pat the areas dry with a microfiber towel and allow at least an hour of drying time before driving the vehicle (NO drying time needed with the dry installation)

• One set of vinyl letters "S,H,E,L,B,Y"

• Limited-lifetime warranty against discoloration, bubbling and peeling due to defective film