Instructions:
1) Using a heatgun, evenly heat up the factory stripes to about 90°F.
2) Remove factory stripes by slowly and evenly pulling away towards the edge you are pulling from, not towards the edge you are working towards.
3) Clean the surface well with 91% Isopropyl Alcohol.
4) Align and tape the rocker stripe kit with painter's tape dividing the kit into two (left and right). One tape in the middle tacking on the top and bottom of the stripe, and one on one of the back end of the stripe (towards wheel) to hold it from rotating.
5) Pull the clear transfer tape slowly ensuring that the stripe kit stays on the clear transfer tape and not on the backing paper.
6) With a pair of scissors, cut the backing paper ONLY to expose your paint behind it.
7) Lay the stripe down making sure that it stays aligned to factory stripes on the door, and then squeegee the kit out.
8) Remove the tape, fold back the rest of the stripe, and remove the backing paper.
9) Lay the rest of the stripe down and squeegee.
10) Remove the transfer tape and wipe clean carefully as to not peel the edges.
